Version:  2.0.40 2.2.26 2.4.37 3.2 3.3 3.4 3.5 3.6 3.7 3.8 3.9 3.10 3.11 3.12 3.13 3.14 3.15 3.16 3.17 3.18

Linux/drivers/w1/masters/Kconfig

  1 #
  2 # 1-wire bus master configuration
  3 #
  4 
  5 menu "1-wire Bus Masters"
  6 
  7 config W1_MASTER_MATROX
  8         tristate "Matrox G400 transport layer for 1-wire"
  9         depends on PCI
 10         help
 11           Say Y here if you want to communicate with your 1-wire devices
 12           using Matrox's G400 GPIO pins.
 13 
 14           This support is also available as a module.  If so, the module
 15           will be called matrox_w1.
 16 
 17 config W1_MASTER_DS2490
 18         tristate "DS2490 USB <-> W1 transport layer for 1-wire"
 19         depends on USB
 20         help
 21           Say Y here if you want to have a driver for DS2490 based USB <-> W1 bridges,
 22           for example DS9490*.
 23 
 24           This support is also available as a module.  If so, the module
 25           will be called ds2490.
 26 
 27 config W1_MASTER_DS2482
 28         tristate "Maxim DS2482 I2C to 1-Wire bridge"
 29         depends on I2C
 30         help
 31           If you say yes here you get support for the Maxim DS2482
 32           I2C to 1-Wire bridge.
 33 
 34           This driver can also be built as a module.  If so, the module
 35           will be called ds2482.
 36 
 37 config W1_MASTER_MXC
 38         tristate "Freescale MXC 1-wire busmaster"
 39         depends on ARCH_MXC || COMPILE_TEST
 40         help
 41           Say Y here to enable MXC 1-wire host
 42 
 43 config W1_MASTER_DS1WM
 44         tristate "Maxim DS1WM 1-wire busmaster"
 45         help
 46           Say Y here to enable the DS1WM 1-wire driver, such as that
 47           in HP iPAQ devices like h5xxx, h2200, and ASIC3-based like
 48           hx4700.
 49 
 50 config W1_MASTER_GPIO
 51         tristate "GPIO 1-wire busmaster"
 52         depends on GPIOLIB
 53         help
 54           Say Y here if you want to communicate with your 1-wire devices using
 55           GPIO pins. This driver uses the GPIO API to control the wire.
 56 
 57           This support is also available as a module.  If so, the module
 58           will be called w1-gpio.
 59 
 60 config HDQ_MASTER_OMAP
 61         tristate "OMAP HDQ driver"
 62         depends on ARCH_OMAP
 63         help
 64           Say Y here if you want support for the 1-wire or HDQ Interface
 65           on an OMAP processor.
 66 
 67 endmenu
 68 

This page was automatically generated by LXR 0.3.1 (source).  •  Linux is a registered trademark of Linus Torvalds  •  Contact us