Version:  2.6.34 2.6.35 2.6.36 2.6.37 2.6.38 2.6.39 3.0 3.1 3.2 3.3 3.4 3.5 3.6 3.7 3.8 3.9 3.10 3.11 3.12 3.13 3.14

Linux/drivers/scsi/arm/Kconfig

  1 #
  2 # SCSI driver configuration for Acorn
  3 #
  4 config SCSI_ACORNSCSI_3
  5         tristate "Acorn SCSI card (aka30) support"
  6         depends on ARCH_ACORN && SCSI
  7         select SCSI_SPI_ATTRS
  8         help
  9           This enables support for the Acorn SCSI card (aka30). If you have an
 10           Acorn system with one of these, say Y. If unsure, say N.
 11 
 12 config SCSI_ACORNSCSI_TAGGED_QUEUE
 13         bool "Support SCSI 2 Tagged queueing"
 14         depends on SCSI_ACORNSCSI_3
 15         help
 16           Say Y here to enable tagged queuing support on the Acorn SCSI card.
 17 
 18           This is a feature of SCSI-2 which improves performance: the host
 19           adapter can send several SCSI commands to a device's queue even if
 20           previous commands haven't finished yet. Some SCSI devices don't
 21           implement this properly, so the safe answer is N.
 22 
 23 config SCSI_ACORNSCSI_SYNC
 24         bool "Support SCSI 2 Synchronous Transfers"
 25         depends on SCSI_ACORNSCSI_3
 26         help
 27           Say Y here to enable synchronous transfer negotiation with all
 28           targets on the Acorn SCSI card.
 29 
 30           In general, this improves performance; however some SCSI devices
 31           don't implement it properly, so the safe answer is N.
 32 
 33 config SCSI_ARXESCSI
 34         tristate "ARXE SCSI support"
 35         depends on ARCH_ACORN && SCSI
 36         help
 37           Around 1991, Arxe Systems Limited released a high density floppy
 38           disc interface for the Acorn Archimedes range, to allow the use of
 39           HD discs from the then new A5000 on earlier models. This interface
 40           was either sold on its own or with an integral SCSI controller.
 41           Technical details on this NCR53c94-based device are available at
 42           <http://www.cryton.demon.co.uk/acornbits/scsi_arxe.html>
 43           Say Y here to compile in support for the SCSI controller.
 44 
 45 config SCSI_CUMANA_2
 46         tristate "CumanaSCSI II support"
 47         depends on ARCH_ACORN && SCSI
 48         help
 49           This enables support for the Cumana SCSI II card. If you have an
 50           Acorn system with one of these, say Y. If unsure, say N.
 51 
 52 config SCSI_EESOXSCSI
 53         tristate "EESOX support"
 54         depends on ARCH_ACORN && SCSI
 55         help
 56           This enables support for the EESOX SCSI card. If you have an Acorn
 57           system with one of these, say Y, otherwise say N.
 58 
 59 config SCSI_POWERTECSCSI
 60         tristate "PowerTec support"
 61         depends on ARCH_ACORN && SCSI
 62         help
 63           This enables support for the Powertec SCSI card on Acorn systems. If
 64           you have one of these, say Y. If unsure, say N.
 65 
 66 comment "The following drivers are not fully supported"
 67         depends on ARCH_ACORN
 68 
 69 config SCSI_CUMANA_1
 70         tristate "CumanaSCSI I support"
 71         depends on ARCH_ACORN && SCSI
 72         select SCSI_SPI_ATTRS
 73         help
 74           This enables support for the Cumana SCSI I card. If you have an
 75           Acorn system with one of these, say Y. If unsure, say N.
 76 
 77 config SCSI_OAK1
 78         tristate "Oak SCSI support"
 79         depends on ARCH_ACORN && SCSI
 80         select SCSI_SPI_ATTRS
 81         help
 82           This enables support for the Oak SCSI card. If you have an Acorn
 83           system with one of these, say Y. If unsure, say N.
 84 

This page was automatically generated by LXR 0.3.1 (source).  •  Linux is a registered trademark of Linus Torvalds  •  Contact us