Version:  2.0.40 2.2.26 2.4.37 2.6.39 3.0 3.1 3.2 3.3 3.4 3.5 3.6 3.7 3.8 3.9 3.10 3.11 3.12 3.13 3.14 3.15

Linux/drivers/pps/clients/Kconfig

  1 #
  2 # PPS clients configuration
  3 #
  4 
  5 if PPS
  6 
  7 comment "PPS clients support"
  8 
  9 config PPS_CLIENT_KTIMER
 10         tristate "Kernel timer client (Testing client, use for debug)"
 11         help
 12           If you say yes here you get support for a PPS debugging client
 13           which uses a kernel timer to generate the PPS signal.
 14 
 15           This driver can also be built as a module.  If so, the module
 16           will be called pps-ktimer.
 17 
 18 config PPS_CLIENT_LDISC
 19         tristate "PPS line discipline"
 20         depends on PPS && TTY
 21         help
 22           If you say yes here you get support for a PPS source connected
 23           with the CD (Carrier Detect) pin of your serial port.
 24 
 25 config PPS_CLIENT_PARPORT
 26         tristate "Parallel port PPS client"
 27         depends on PPS && PARPORT
 28         help
 29           If you say yes here you get support for a PPS source connected
 30           with the interrupt pin of your parallel port.
 31 
 32 config PPS_CLIENT_GPIO
 33         tristate "PPS client using GPIO"
 34         depends on PPS
 35         help
 36           If you say yes here you get support for a PPS source using
 37           GPIO. To be useful you must also register a platform device
 38           specifying the GPIO pin and other options, usually in your board
 39           setup.
 40 
 41 endif

This page was automatically generated by LXR 0.3.1 (source).  •  Linux is a registered trademark of Linus Torvalds  •  Contact us