Version:  2.0.40 2.2.26 2.4.37 3.2 3.3 3.4 3.5 3.6 3.7 3.8 3.9 3.10 3.11 3.12 3.13 3.14 3.15 3.16 3.17 3.18

Linux/drivers/net/wireless/cw1200/Kconfig

  1 config CW1200
  2         tristate "CW1200 WLAN support"
  3         depends on MAC80211 && CFG80211
  4         help
  5           This is a driver for the ST-E CW1100 & CW1200 WLAN chipsets.
  6           This option just enables the driver core, see below for
  7           specific bus support.
  8 
  9 if CW1200
 10 
 11 config CW1200_WLAN_SDIO
 12         tristate "Support SDIO platforms"
 13         depends on CW1200 && MMC
 14         help
 15           Enable support for the CW1200 connected via an SDIO bus.
 16           By default this driver only supports the Sagrad SG901-1091/1098 EVK
 17           and similar designs that utilize a hardware reset circuit. To
 18           support different CW1200 SDIO designs you will need to override
 19           the default platform data by calling cw1200_sdio_set_platform_data()
 20           in your board setup file.
 21 
 22 config CW1200_WLAN_SPI
 23         tristate "Support SPI platforms"
 24         depends on CW1200 && SPI
 25         help
 26           Enables support for the CW1200 connected via a SPI bus.  You will
 27           need to add appropriate platform data glue in your board setup
 28           file.
 29 
 30 endif

This page was automatically generated by LXR 0.3.1 (source).  •  Linux is a registered trademark of Linus Torvalds  •  Contact us