Version:  2.0.40 2.2.26 2.4.37 3.2 3.3 3.4 3.5 3.6 3.7 3.8 3.9 3.10 3.11 3.12 3.13 3.14 3.15 3.16 3.17 3.18

Linux/drivers/net/hippi/Kconfig

  1 #
  2 # HIPPI network device configuration
  3 #
  4 
  5 config HIPPI
  6         bool "HIPPI driver support"
  7         depends on INET && PCI
  8         ---help---
  9           HIgh Performance Parallel Interface (HIPPI) is a 800Mbit/sec and
 10           1600Mbit/sec dual-simplex switched or point-to-point network. HIPPI
 11           can run over copper (25m) or fiber (300m on multi-mode or 10km on
 12           single-mode). HIPPI networks are commonly used for clusters and to
 13           connect to super computers. If you are connected to a HIPPI network
 14           and have a HIPPI network card in your computer that you want to use
 15           under Linux, say Y here (you must also remember to enable the driver
 16           for your HIPPI card below). Most people will say N here.
 17 
 18 if HIPPI
 19 
 20 config ROADRUNNER
 21         tristate "Essential RoadRunner HIPPI PCI adapter support"
 22         depends on PCI
 23         ---help---
 24           Say Y here if this is your PCI HIPPI network card.
 25 
 26           To compile this driver as a module, choose M here: the module
 27           will be called rrunner.  If unsure, say N.
 28 
 29 config ROADRUNNER_LARGE_RINGS
 30         bool "Use large TX/RX rings"
 31         depends on ROADRUNNER
 32         ---help---
 33           If you say Y here, the RoadRunner driver will preallocate up to 2 MB
 34           of additional memory to allow for fastest operation, both for
 35           transmitting and receiving. This memory cannot be used by any other
 36           kernel code or by user space programs. Say Y here only if you have
 37           the memory.
 38 
 39 endif # HIPPI

This page was automatically generated by LXR 0.3.1 (source).  •  Linux is a registered trademark of Linus Torvalds  •  Contact us