Version:  2.0.40 2.2.26 2.4.37 3.6 3.7 3.8 3.9 3.10 3.11 3.12 3.13 3.14 3.15 3.16 3.17 3.18 3.19 4.0 4.1 4.2

Linux/drivers/net/ethernet/via/Kconfig

  1 #
  2 # VIA device configuration
  3 #
  4 
  5 config NET_VENDOR_VIA
  6         bool "VIA devices"
  7         default y
  8         ---help---
  9           If you have a network (Ethernet) card belonging to this class, say Y.
 10 
 11           Note that the answer to this question doesn't directly affect the
 12           kernel: saying N will just cause the configurator to skip all
 13           the questions about VIA devices. If you say Y, you will be asked for
 14           your specific card in the following questions.
 15 
 16 if NET_VENDOR_VIA
 17 
 18 config VIA_RHINE
 19         tristate "VIA Rhine support"
 20         depends on (PCI || OF_IRQ)
 21         depends on HAS_DMA
 22         select CRC32
 23         select MII
 24         ---help---
 25           If you have a VIA "Rhine" based network card (Rhine-I (VT86C100A),
 26           Rhine-II (VT6102), or Rhine-III (VT6105)), say Y here. Rhine-type
 27           Ethernet functions can also be found integrated on South Bridges
 28           (e.g. VT8235).
 29 
 30           To compile this driver as a module, choose M here. The module
 31           will be called via-rhine.
 32 
 33 config VIA_RHINE_MMIO
 34         bool "Use MMIO instead of PIO"
 35         depends on VIA_RHINE
 36         ---help---
 37           This instructs the driver to use PCI shared memory (MMIO) instead of
 38           programmed I/O ports (PIO). Enabling this gives an improvement in
 39           processing time in parts of the driver.
 40 
 41           If unsure, say Y.
 42 
 43 config VIA_VELOCITY
 44         tristate "VIA Velocity support"
 45         depends on (PCI || (OF_ADDRESS && OF_IRQ))
 46         depends on HAS_DMA
 47         select CRC32
 48         select CRC_CCITT
 49         select MII
 50         ---help---
 51           If you have a VIA "Velocity" based network card say Y here.
 52 
 53           To compile this driver as a module, choose M here. The module
 54           will be called via-velocity.
 55 
 56 endif # NET_VENDOR_VIA

This page was automatically generated by LXR 0.3.1 (source).  •  Linux is a registered trademark of Linus Torvalds  •  Contact us