Version:  2.0.40 2.2.26 2.4.37 3.6 3.7 3.8 3.9 3.10 3.11 3.12 3.13 3.14 3.15 3.16 3.17 3.18 3.19 4.0 4.1 4.2

Linux/drivers/net/ethernet/myricom/Kconfig

  1 #
  2 # Myricom device configuration
  3 #
  4 
  5 config NET_VENDOR_MYRI
  6         bool "Myricom devices"
  7         default y
  8         depends on PCI && INET
  9         ---help---
 10           If you have a network (Ethernet) card belonging to this class, say Y.
 11 
 12           Note that the answer to this question doesn't directly affect the
 13           kernel: saying N will just cause the configurator to skip all
 14           the questions about Myricom cards. If you say Y, you will be asked for
 15           your specific card in the following questions.
 16 
 17 if NET_VENDOR_MYRI
 18 
 19 config MYRI10GE
 20         tristate "Myricom Myri-10G Ethernet support"
 21         depends on PCI && INET
 22         select FW_LOADER
 23         select CRC32
 24         ---help---
 25           This driver supports Myricom Myri-10G Dual Protocol interface in
 26           Ethernet mode. If the eeprom on your board is not recent enough,
 27           you will need a newer firmware image.
 28           You may get this image or more information, at:
 29 
 30           <http://www.myri.com/scs/download-Myri10GE.html>
 31 
 32           To compile this driver as a module, choose M here. The module
 33           will be called myri10ge.
 34 
 35 config MYRI10GE_DCA
 36         bool "Direct Cache Access (DCA) Support"
 37         default y
 38         depends on MYRI10GE && DCA && !(MYRI10GE=y && DCA=m)
 39         ---help---
 40           Say Y here if you want to use Direct Cache Access (DCA) in the
 41           driver.  DCA is a method for warming the CPU cache before data
 42           is used, with the intent of lessening the impact of cache misses.
 43 
 44 endif # NET_VENDOR_MYRI

This page was automatically generated by LXR 0.3.1 (source).  •  Linux is a registered trademark of Linus Torvalds  •  Contact us