Version:  2.0.40 2.2.26 2.4.37 3.2 3.3 3.4 3.5 3.6 3.7 3.8 3.9 3.10 3.11 3.12 3.13 3.14 3.15 3.16 3.17 3.18

Linux/drivers/net/ethernet/micrel/Kconfig

  1 #
  2 # Micrel device configuration
  3 #
  4 
  5 config NET_VENDOR_MICREL
  6         bool "Micrel devices"
  7         default y
  8         depends on (HAS_IOMEM && DMA_ENGINE) || SPI || PCI || HAS_IOMEM || \
  9                    (ARM && ARCH_KS8695)
 10         ---help---
 11           If you have a network (Ethernet) card belonging to this class, say Y
 12           and read the Ethernet-HOWTO, available from
 13           <http://www.tldp.org/docs.html#howto>.
 14 
 15           Note that the answer to this question doesn't directly affect the
 16           kernel: saying N will just cause the configurator to skip all
 17           the questions about Micrel devices. If you say Y, you will be asked
 18           for your specific card in the following questions.
 19 
 20 if NET_VENDOR_MICREL
 21 
 22 config ARM_KS8695_ETHER
 23         tristate "KS8695 Ethernet support"
 24         depends on ARM && ARCH_KS8695
 25         select MII
 26         ---help---
 27           If you wish to compile a kernel for the KS8695 and want to
 28           use the internal ethernet then you should answer Y to this.
 29 
 30 config KS8842
 31         tristate "Micrel KSZ8841/42 with generic bus interface"
 32         depends on HAS_IOMEM && DMA_ENGINE
 33         ---help---
 34           This platform driver is for KSZ8841(1-port) / KS8842(2-port)
 35           ethernet switch chip (managed, VLAN, QoS) from Micrel or
 36           Timberdale(FPGA).
 37 
 38 config KS8851
 39         tristate "Micrel KS8851 SPI"
 40         depends on SPI
 41         select MII
 42         select CRC32
 43         select EEPROM_93CX6
 44         ---help---
 45           SPI driver for Micrel KS8851 SPI attached network chip.
 46 
 47 config KS8851_MLL
 48         tristate "Micrel KS8851 MLL"
 49         depends on HAS_IOMEM
 50         select MII
 51         ---help---
 52           This platform driver is for Micrel KS8851 Address/data bus
 53           multiplexed network chip.
 54 
 55 config KSZ884X_PCI
 56         tristate "Micrel KSZ8841/2 PCI"
 57         depends on PCI
 58         select MII
 59         select CRC32
 60         ---help---
 61           This PCI driver is for Micrel KSZ8841/KSZ8842 PCI Ethernet chip.
 62 
 63           To compile this driver as a module, choose M here. The module
 64           will be called ksz884x.
 65 
 66 endif # NET_VENDOR_MICREL

This page was automatically generated by LXR 0.3.1 (source).  •  Linux is a registered trademark of Linus Torvalds  •  Contact us