Version:  2.0.40 2.2.26 2.4.37 3.1 3.2 3.3 3.4 3.5 3.6 3.7 3.8 3.9 3.10 3.11 3.12 3.13 3.14 3.15 3.16 3.17

Linux/drivers/net/ethernet/adaptec/Kconfig

  1 #
  2 # Adaptec network device configuration
  3 #
  4 
  5 config NET_VENDOR_ADAPTEC
  6         bool "Adaptec devices"
  7         default y
  8         depends on PCI
  9         ---help---
 10           If you have a network (Ethernet) card belonging to this class, say Y
 11           and read the Ethernet-HOWTO, available from
 12           <http://www.tldp.org/docs.html#howto>.
 13 
 14           Note that the answer to this question doesn't directly affect the
 15           kernel: saying N will just cause the configurator to skip all
 16           the questions about Adaptec cards. If you say Y, you will be asked for
 17           your specific card in the following questions.
 18 
 19 if NET_VENDOR_ADAPTEC
 20 
 21 config ADAPTEC_STARFIRE
 22         tristate "Adaptec Starfire/DuraLAN support"
 23         depends on PCI
 24         select CRC32
 25         select MII
 26         ---help---
 27           Say Y here if you have an Adaptec Starfire (or DuraLAN) PCI network
 28           adapter. The DuraLAN chip is used on the 64 bit PCI boards from
 29           Adaptec e.g. the ANA-6922A. The older 32 bit boards use the tulip
 30           driver.
 31 
 32           To compile this driver as a module, choose M here: the module
 33           will be called starfire.  This is recommended.
 34 
 35 endif # NET_VENDOR_ADAPTEC

This page was automatically generated by LXR 0.3.1 (source).  •  Linux is a registered trademark of Linus Torvalds  •  Contact us