Version:  2.0.40 2.2.26 2.4.37 3.10 3.11 3.12 3.13 3.14 3.15 3.16 3.17 3.18 3.19 4.0 4.1 4.2 4.3 4.4 4.5 4.6 4.7

Linux/arch/mips/lantiq/Kconfig

  1 if LANTIQ
  2 
  3 config SOC_TYPE_XWAY
  4         bool
  5         select PINCTRL_XWAY
  6         default n
  7 
  8 choice
  9         prompt "SoC Type"
 10         default SOC_XWAY
 11 
 12 config SOC_AMAZON_SE
 13         bool "Amazon SE"
 14         select SOC_TYPE_XWAY
 15 
 16 config SOC_XWAY
 17         bool "XWAY"
 18         select SOC_TYPE_XWAY
 19         select HW_HAS_PCI
 20 
 21 config SOC_FALCON
 22         bool "FALCON"
 23         select PINCTRL_FALCON
 24 
 25 endchoice
 26 
 27 choice
 28         prompt "Built-in device tree"
 29         help
 30           Legacy bootloaders do not pass a DTB pointer to the kernel, so
 31           if a "wrapper" is not being used, the kernel will need to include
 32           a device tree that matches the target board.
 33 
 34           The builtin DTB will only be used if the firmware does not supply
 35           a valid DTB.
 36 
 37 config LANTIQ_DT_NONE
 38         bool "None"
 39 
 40 config DT_EASY50712
 41         bool "Easy50712"
 42         depends on SOC_XWAY
 43         select BUILTIN_DTB
 44 endchoice
 45 
 46 config PCI_LANTIQ
 47         bool "PCI Support"
 48         depends on SOC_XWAY && PCI
 49 
 50 config XRX200_PHY_FW
 51         bool "XRX200 PHY firmware loader"
 52         depends on SOC_XWAY
 53 
 54 endif

This page was automatically generated by LXR 0.3.1 (source).  •  Linux is a registered trademark of Linus Torvalds  •  Contact us